After runcam2 is turned on, there will be two modes when connecting to the computer, USB memory card mode and USB camera mode. Press the power button to switch between the two modes.
Generally, after the camera is connected to the computer, it can be used directly by opening the amcap software.
If it can’t be used, the camera may be occupied by other drivers, just update the driver.
The following is an example of driving iCatch:
Open the device manager and find the driver iCatch
Generally, after the camera is connected to the computer, it can be used directly by opening the amcap software.
If it can’t be used, the camera may be occupied by other drivers, just update the driver.
The following is an example of driving iCatch:
Open the device manager and find the driver iCatch
①
②
③
④
⑤
⑥ OK
Comments