How to use remote cable on Split 1/2/Mini?

Setting Steps

1. Connect the remote cable as shown in the diagram below:

2. Connect the PWM servo plug into an available PWM channel(e.g. CH5 corresponds to switch SA) of your PWM receiver.

3. Set in the OSD Menu:

General > Control Mode > [PWM]

4. Quit OSD Menu and power off. 

5. Power on the camera and use your pre-set switch(e.g. SA) to control your camera:

Toggle rapidly twice is to change video/photo mode, toggle once is to start/stop recording or take photos.

You may refer to:

Have more questions? Submit a request